1. Rotate the chain so that the chain connector is on the bottom. If the chain is longer than your window sill then proceed to step 2 otherwise skip to step 4.
|
2. Unhook the chain connector and lift one end up to where the chain will loop and fit completely within the window opening by a couple inches.
|
|
3. At the point you found in step 2, cut the chain.
|
4. With the chain unlocked from the chain connector, thread the chain through the hold down bracket and reconnect the chain ends with the chain connector.
|
|
5. Fasten the hold down bracket to the inside of the window sill so that there is a slight amount of slack in the chain.
|
6. Rotate the chain so that the chain connector is positioned against the hold down bracket. Now attach the shade and roll it from a fully open position to where it is closed (All the way down).
|
|
7. With the shade completely down over the window place the ball lock on the chain so that it can not be pulled down farther than this position.
|
|
