|
Contact CustomWholesaleBlinds
Phone: 1-888-877-1860
Sales@customwholesaleblinds.com
|
|
Hours (eastern time):
Mon-Fri: 9:00am till 5:00pm
Sat-Sun: Closed
|
|
Home » Spring Roller Shades Install Instructions »
|
Inside Mount Spring Roller Shades Installation & Tension Adjust Instructions
Click for Print Friendly Layout
For an inside mount you will receive two brackets. One has a slotted hole and the other just has a round hole in middle. The slotted bracket is the control end bracket which mounts on the left side (when facing the window). The one with a round hole mounts on right.
Be sure to mount the top edge of the brackets at least 1/4" from top of window (so shade roll doesn't hit top of window). The oval install holes should face the bottom of window. Install the included screws in both the top and bottom holes.
Hanging the shade - Place the pin side of the shade (right end) into the round hole first, then slip the control (flat) end into it's bracket.
Photo's below show how to adjust the tension for the spring roller.
|
|
|
|
|
|
|
5350 NW 165th St, Miami, Florida 33014 Phone: 1-888-877-1860 Email: CustomerService@customwholesaleblinds.com
Copyright - customwholesaleblinds.com Home Decor Partners Website Comments Trade Organizations Blinds 101
|
|